Fabric tutorial The latest hair artifact ourselves DIY twist clamp magic hair band super good looking fashion item
Xiaobian prepared a lot of sewing and dry goods for everyone, welcome everyone to click below [Sprout Community By Sewing Home] Small card, in the circulation, discuss it together ~
Finally, 100 free places have hurry.
! ! !
The headline search for the sewing home and found more exciting sewing video!
Summer long hair is really hot ~
Nowadays, many fairy use big grip.
But Xiaobian recently found a fun
You can DIY hairpin
This is really fired recently.
All kinds of short video pushing, itching ~
I just found the tutorial worth a new thing to do it. All kinds of small flower cloths can be used!
Twisted clip magic hair band
There is a hardness fabric such as a hip cloth, a twill, denim, and a soft cloth that requires hot lining.
Finished product size: vertical 10 cm x level 36 cm · cloth: 2 vertical 12 cm X horns 38 cm · Aluminum wire: 2 mm ~ 3 mm x 100 cm
Start to make
Two pieces were sewed together to facilitate the front of the two cloths and sewed on the red dashed lines in the center. Please refer to the photo decision location. Leave a return of approximately 7 cm on the lower side.
Make a notch on the inner side, but cut in the middle and both ends, just like the leaves of the leaves.
Topped from the return to the front.
Ironed and shaped with an iron.
The burn is stitched to Iron.
Sewing starts from the top.
When the volume is close to the bottom end, the above piece of cloth is covered with a good portion.
The following one piece is opened to the other side to wrap the cloth.
Sewing with 5 mm seams.
Pull out the cloth inside from the right or left, it will return to the front.
The other side is sewn by the same method.
Expand on both sides.
Folding edges, 1 cm of seam edges.
Return from the return port to the front and organize it.
Inserting aluminum wires is approximately 1 cm wide. At this time, the opening state is kept open.
The position of the aluminum wire opening should correspond to the position of the center opening.
Wrap the end of the aluminum wire.
The center opening puts the aluminum inserted the aluminum filament opening and bypass the outside (yellow path) once. If it is very long, cut it and screw it together at the end of the wire.
the fourth step
Suture opening suture center and edge of the edge.
The edges of the hole are vertically sewed for two or three times to enhance it.
Source | 喵 Village manual
This issue of DIY handmade fabric cute hairpin Do you like it? Did you learn? Vote, share the fabric tutorial you want to see in the review area ~
For the previous period, do you have to read!
Main title: Share ten sewing practical tips! Society is better than good teacher! (superior)
“Waste Use”, don’t know more than a doxy of jeans
Tips, pants, waist is not suitable, two methods teach you to change
Reconstruction 丨 How to change the round neck T-shirt to V-neck (tip skill) –
If you like the home of the sewing, you can click on the “Learn more” in the lower left corner.
I like to see which tutorials, I can leave a message at the bottom of the comment area ~ I am the highest one, Xiaobian will take the tutorial.
! ! !