Improve the heat dissipation of wireless network card: TP-LINK wireless USB network card violent dismantling modification

0 Comments

改善无线网卡的散热:TP-LINK无线USB网卡暴力拆解改装

The landlord is not very perfect because it is comparative early, so the network wiring is not very perfect because the network cable is located in the old sister room, and there is no wire in the wall. So when I started using the Internet in the first two years, I gave me the room ( The Sister’s room has a USB wireless network card with a desktop computer of the four-five walls.

In the past two years, I lost my humiliation. When I was cool, I was fine. The weather was hot. I was like a wind. Every two or three minutes, I have two thousand milliseconds, even more than two thousand milliseconds. Can’t bear it! ! ! At the beginning, I thought it was the performance problem of wireless routing. When I disconnected the route, or the adjustment route is in the middle of the antenna direction, and there is a small bridge of the Router router in the middle. Later, I found it is a wireless network card problem, and from Tengda Changed to TP, although the signal was better, but still fled the 魔 魔. . .

Later, I found it slowly. I also found that the temperature of the network card was high, especially in the summer, the hot, and finally I determined that the network card was working for a long time and the room temperature is high, which causes not normal. Net (nonsense, there is no topic)

Ok, now I will get a disassembly, the landlord just bought a TP wireless network card TL-WN823N

Tools are: 5 inch shear clamp, thermal silicone, small heat sink

First give the pig’s foot a radio: domestic work is so good, there is no joining gap, watch the online saying is ultrasonic suture technology, completely sealed

First, give the NIC to the clothes, the hot day is still so thick, it is no wonder that you die.

改善无线网卡的散热:TP-LINK无线USB网卡暴力拆解改装

Give everyone a little 55 yuan, it is probably like this, the chip is a crab, the heat sink is installed there.

改善无线网卡的散热:TP-LINK无线USB网卡暴力拆解改装

Get the USB shell out because the heat sink is a bit big, and the metal border around the PCB board also uses a shears to ensure that the heat sink can be installed.

改善无线网卡的散热:TP-LINK无线USB网卡暴力拆解改装

Later, I found that the heat sink is big, cut off a small piece, um, just good

改善无线网卡的散热:TP-LINK无线USB网卡暴力拆解改装

Well, it is also the most essential step in the end, and the silicon is installed.

Well, I’m big.

改善无线网卡的散热:TP-LINK无线USB网卡暴力拆解改装

Finally, the experience is left, the blue light is on, and it is proved that it is not destroyed to the small part.

Because I really can’t rest in the windless summer night, the landlord silently opened the empty (KAI) adjustment (GuA)

改善无线网卡的散热:TP-LINK无线USB网卡暴力拆解改装

However, I tested it before I opened the air conditioner. I really thought that it was more smooth than before, and ping had a smooth, but the request timeout still appeared (Nima, the leader of the landlord was nonsense, and the last still broken network)

改善无线网卡的散热:TP-LINK无线USB网卡暴力拆解改装

Thank you for watching, shooting with curiosity.

Improve the heat dissipation of wireless network card: TP-LINK wireless USB network card violent dismantling modification